PROUDLY MADE IN THE USA
Circuit Caddy XL
Envision #: CCXL-01
The Circuit Caddy XL has a never before seen A-frame built with a 7 guage steel designed to last a lifetime. It comes with (2) larger 1 7/8" SCH40 steel axles for larger spools of wire and acts as a guide when pulling wire from the backside of the cart as the wire pulls straight up and over the axle keeping the wire from getting tangled up. The Circuit Caddy XL also comes with (10) oversized 3/4" solid steel axles for smaller #14 - #6 cable. It's unique design makes it the ultimate wire cart for any large commercial job site. The Circuit Caddy XL was built to handle (4) 1000' spools of MC cable or (4) 24" spools. The lower axle was set at a specific height to roll the wire up onto the cart on the smaller axles. Simply slide the larger axle through both spools and remove the smaller axles on the bottom and begin to pull.
Patent Pending
Features & Benefits
- Unique taller A-Frame design built to center the weight of the wire and give you more room for multiple conductors.
- Solid steel 7 gauge welded frame designed to last a lifetime. Just bolt on the casters, and you’re ready to pull wire.
- Multi-use universal wire cart built to handle MC cable to # 14 wire for low voltage controls.
- Built with forklift pockets so you can load the cart on a reach forklift and pull wire outside for light pole bases, signage, and more.
- You can also use it as a flat cart and load up boxes of wire or fittings and move them around a job site.
- Built right here in the USA and comes with a 5 year warranty.
Specifications
Envision #
CCXL-01
Weight
152 lbs (with axles)
Load Capacity
1200 lbs
Diminsions
30 1/4"L X 47" H X 36 1/4" W
Wire Capacity**
#12 - 500'
#12 - 2500'
#10 - 500'
#8 - 500'
#8 - 1000'
#6 - 500'
MC - 1000"
60
10
40
25
10
10
4
**of each wire size, not all sizes at the same time
